Polycom RSS 2000 User Manual download pdf (Page 10)

RSS 2000 Getting Started Guide & Release Notes – Version 3.0.2

First Time Installation and Configuration

Preparations

Obtain the following information from your network administrator:

• RSS 2000 unit, Subnet Mask and Default Gateway IP addresses

• Gatekeeper IP address, Prefix, and E.164 of the RSS 2000.

Unpacking and Installing the RSS 2000

1 Place the RSS 2000 unit on a stable flat surface in the selected location.

2 To connect to the power source, insert the power cable into the Power connector

on the rear panel of the MGC+ unit and insert the Power cable into the power

source socket.

3 Connect the LAN cable to LAN1 in the back of the system.

4 Turn on the power switch.

Initial RSS 2000 IP Configuration

The system is shipped with a default IP configuration:

IP Address:192.168.1.254

Subnet Mask: 255.255.255.0

Gateway: 192.168.1.1

There are two ways to change the initial IP address of the sytem:

• Via a cross over LAN cable

• Via a RS232 or Telnet Console.

Changing the initial IP address via a cross over LAN cable

1 Connect a cross over LAN cable to LAN1 in the RSS 2000.

2 Set your laptop to the same segment of the RSS

For example (in your laptop IP config setting):

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

Polycom RSS 2000 User Manual Page 10