Polycom DOC2231A User Manual download pdf (Page 18)

Chapter 2 - Hardware Installation

2-6

Mounting the MGC+100 in a 23” Rack

The MGC+100 can be mounted in a 23” rack using the two mounting plates

that are pre-installed on the unit.

1. Make sure that the MCU is turned OFF and it is disconnected from the

AC power.

2. Place the MCU in a 23” rack and support it, screw the mounting brackets

to the rack securing it with bolts and

self-locking nuts (which the client provides).

If the MGC+100 was shipped without the two mounting plates that are

usually pre-installed, refer to the MGC+ Hardware and Installation Manual,

Chapter 2 for a detailed description of the installation process.

For a detailed description of mounting the MGC+100 in a 19” rack, see the

MGC+ Hardware and Installation Manual, Chapter 2.

When the unit is installed on a rack, the rack must be properly grounded to the

central office ground. The rack must be grounded with two-hole compression-

type connectors using copper conductors (tinned or untinned). Wire, bus bar or

braided strap connectors are acceptable.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 115 116

No comments

Polycom DOC2231A User Manual Page 18