Release Notes
Polycom PVX 6.0.2
pvx_rel602
The camera configuration dialogs are provided by the camera vendor and may not be
translated into all languages.
Interoperability and Compatibility Issues
Cisco VPN
This version of Polycom PVX supports Cisco VPN software version 4.0.3F and higher.
Ezenia! MCU
When using the Polycom PVX software with an Ezenia! MCU version 6.0, AES
encryption needs to be disabled.
Microsoft NetMeeting
The Polycom PVX application does not support G.723 audio when using a web cam. This
means that connections to endpoints like NetMeeting that used to connect at G.723 may
now connect with G.711. The call rate must be increased to 128 kbps or above or there
will be no video.
Polycom Global Management System
GMS managers may notice incorrect caller ID listed under the Call Status tab in the GMS
manager. This occurs when a Polycom PVX is in a videoconference call with a
ViewStation FX.
Polycom iPower
T.120 does not work with an iPower if the iPower is configured for encryption required.
iPower systems do not accept transferred calls from Polycom PVX 6.0.2 at this time.
Polycom MGC-100
Polycom PVX 6.0.2 does not support sending snapshots when in a conference call with
an MGC-100 using H.261 protocols. To correct: Reestablish call using H.263 protocols.
Users may experience ghosting and freezing image video when in a videoconference call
with an MGC-100 bridge running software version 5.0. MGC version 5.1 addresses this
issue.
Polycom PathNavigator
Users may experience an audio screech when in a Conference on Demand call. This is
caused when one or more of the conference parties are placed on mute. To correct, users
should un-mute the far sites.
If you establish a PathNavigator address as your system gatekeeper, the Call Forward
When Busy settings may not be saved upon exiting the Polycom PVX application.
Call Transfer cannot currently be used when you are in a call using Conference on
Demand.
T.120 is not supported in a Conference on Demand call.
Users may experience poor video quality when only one endpoint is using PathNavigator
5.0. Use one of the following options to correct:
• Register both end points with PathNavigator 5.0.
• De-select PathNavigator and re-establish the call.
Polycom WebOffice
updated 1.18.2005
- 11 -
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals