Polycom V2IU User Manual download pdf (Page 27)

Configuring Network Settings

4 - 3

To configure provider interface settings:

1. In the navigation bar, select Network

2. In Provider Interface Settings, select Static IP Address (the most common

configuration), or DHCP if a DHCP server assigns the 6400-S's internal

address.

3. Enter an IP Address.

4. Enter a Subnet Mask.

5. If you are configuring network settings, see the instructions in

"Configuring the Network " on page 20

6. If you want to configure a management interface that is different than the

default, complete all of the configuration tasks, then see Configuring a

management interface on page 7-9.

7. Press Submit.

Setting the Ethernet link rate

Ethernet autonegotiation is often unreliable, especially between different

vendors or old and new networking equipment. Failure of autonegotiation is

generally not a cause for concern. However, if the negotiated rates change

intermittently or the link is reported as no link or down, the link rate may need

to be set manually. An interface that "flutters" because of the autonegotiation

setting, may cause intermittent voice and data outages.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 81 82

No comments

Polycom V2IU User Manual Page 27